LM series vertical mills can be widely used in cement, electric power, metallurgy, chemical, non-metallic mining and other industries, and focus on the three major areas of non-metallic mining, coal powder and slag.
LM-K series vertical mill suit for process cement raw meal, power desulfurization powder, gypsum powder, weathered metal ore, non-metallic ore and its sintered ore, etc. Mohs hardness below 4, density below 4.6, compressive strength below 170Mpa, non-flammable and explosive ore, Non-corrosive brittle materials.
LM-M series Coal mill for thermal power generation, steel mills, and coal injection boilers.
LM-N series vertical mill suit for process slag, fly ash, bauxite, metal ore, weathered quartz, feldspar, granite, etc.Mohs hardness is 4-6, density is below 4.6, compressive strength is 170~240Mpa, non-flammable and explosive.
Low Investment Cost
Because it integrates crushing, drying, grinding, grading, and conveying, the system is simple, the layout is compact, the area is small, and it can be laid out in the open air, so the investment cost can be greatly reduced.
Low Operating Cost
High Drying Efficiency
The hot air introduced into the mill from the outside is in direct contact with the powdery materials many times in the mill, and the drying capacity is strong. It can save a dryer for the mill system and save energy. By adjusting the temperature of the hot air, It can meet the requirements of different humidity materials.
Simple Operation And Maintenance
Stable Product Quality
Environmentally Friendly And Clean
The vibration is small, the noise is low, and the equipment is sealed as a whole, the system works under negative pressure, there is little dust spillage, the environment is clean, and it meets the national environmental protection requirements.